Home: Waterjet Frequently Asked Questions
Q) What materials can be cut with an Abrasive Water Jet machine?
A) Almost anything at all with the possible exception of Toughened Glass (cut first and toughen after)
Q) Does the water damage the part?
A) No, the velocity is so high it won’t even get wet (unless the water in the tank is splashed back on the underside).
Q) How small part can be cut?
A) Less than two or three mm square
Q) How large a part can be cut?
A) Size is only limited by the work area of the machine.
Q) How thick can the part be?
A) 150mm in most materials
Q) Is the edge of the part damaged by the process?
A) No there is no stressed or heat affected zone and often no burr.
Q) Is it a competitive process
A) Yes, with genuine machine tool accuracy, no additional cost in jigs and fixtures and only one cutting ‘tool’ it is often quicker for low volume parts.